#include "uart.h"
#include "fsl_common.h"
#include "fsl_debug_console.h"

void uart_tx_pin(void)
{
	/* Enable IOCON Clock */
	CLOCK_EnableClock(kCLOCK_Iocon);
	
	/* Enable Uart Clock IP */ 
	    const uint32_t port0_pin30_config = (/* Pin is configured as FC0_TXD_SCL_MISO_WS */
                                         0x01u |
                                         /* No addition pin function */
                                         0x00u |
                                         /* Standard mode, output slew rate control is enabled */
                                         0x00u |
                                         /* Input function is not inverted */
                                         0x00u |
                                         /* Enables digital function */
                                         0x0100u |
                                         /* Open drain is disabled */
                                         0x00u);
    /* PORT0 PIN30 (coords: 94) is configured as FC0_TXD_SCL_MISO_WS */
		IOCON->PIO[0U][30U] = port0_pin30_config;

}

void uart_rx_pin(void)
{
	/* Enable IOCON Clock */
	CLOCK_EnableClock(kCLOCK_Iocon);
	
	/* Enable Uart Clock IP */ 
	    const uint32_t port0_pin29_config = (/* Pin is configured as FC0_TXD_SCL_MISO_WS */
                                         0x01u |
                                         /* No addition pin function */
                                         0x00u |
                                         /* Standard mode, output slew rate control is enabled */
                                         0x00u |
                                         /* Input function is not inverted */
                                         0x00u |
                                         /* Enables digital function */
                                         0x0100u |
                                         /* Open drain is disabled */
                                         0x00u);
    /* PORT0 PIN30 (coords: 94) is configured as FC0_TXD_SCL_MISO_WS */
		IOCON->PIO[0U][29U] = port0_pin29_config;

}

void uart_init(void){
	uart_tx_pin();
	uart_rx_pin();
	CLOCK_AttachClk(kFRO12M_to_FLEXCOMM0);
	RESET_ClearPeripheralReset(kFC0_RST_SHIFT_RSTn);
	uint32_t uartClkSrcFreq = 12000000U;
	DbgConsole_Init(0, 115200U, kSerialPort_Uart, uartClkSrcFreq);
	
}